PDA

View Full Version : bt of adviced wanted



Simo429
28-01-2009, 14:44
sorry if this isnt the place to post this

whats the best way to put flame damage onto flamers?

BLZBOB
28-01-2009, 15:49
Better in P&T but I'll leave that to a mod. To answer your question the moethod have found best is basecoat the nozzlt tin bits then drybrush boltgun metal then the last 50% of the nozzle gets hit with tinbitz again, then about 25% from then end a scorched brown and finally at the end a black.

MrGiggles
28-01-2009, 19:30
Assuming your nozzle is roughly Chainmail in colour, paint the end of the nozzle Shining Gold, starting to thin the coat about three quarters of the way from the end of the nozzle. Drybrush Chaos Black (or another black so long as it provides a matte finish) onto the nozzle. Go heavy at the front and gradually lighten the drybrush as you move further from the front of the nozzle. From there, finish up the model and seal it. Once the sealant is dry, go back to the nozzle and give it some brown ink. It'll give it the charred and heat damaged look.