A few weeks ago I had an idea to pull out all the assorted terrain and battlefield accessories and make terrain out of them all with different ideas and combinations in mind.
I am currently working on two different terrain pieces.
A Gothic Ruin terrain piece and a Ruined Building terrain piece
The first Gothic Ruin is using some of GW's old Gothic ruin sprues along with an assortment of battlefield accessories such barriers and razor wire.
The second is using some of GW's old foam ruined buildings. I also plan to use other battles accessories such as tank traps. Does anyone remember these or know of anyone willing to part with one set?
Gothic Ruin Progress
The first step was to saw, cut, and trim down the Gothic ruins so I could make tow sets which match. One set would be the outer set of ruins while one set would be the inner set of ruins. When placing the ruins I was puzzled as to where a door would had been, but decided to go against an outer door and make ruins some sort of holding cell. Hidden trap doors would be the only way in or out.
So the current setup looks like this.
This terrain piece will support regular and maybe medium size infantry units. Large units will most likely be blocked along with vehicles.
Ruined Building progress
I tried to use the smaller section as an upper story, but I was not liking it at all. I asked my fiance for an opinion and she changed the arrangement and I like her interpretation much better. The entrance was kept in a corner, but trimmed down a bit further.
So the current setup looks like this.
This terrain piece will support regular and medium size infantry units and perhaps large. Vehicles will be blocked.
Currently weather is not allowing me to spray paint. Plus I am wondering if the 1/8 inch Birchwood for the base will be sufficient and not warp compared to hardboard which I have not found locally yet.
Let me know what you think as I proceed.
My next steps are
Undercoat Gothic Ruin sprues
Undercoat Ruined Building pieces manually
Decide on bottom floor (Birchwood) undercot black only or undercoat black and add a layer or textur (Fine Ballast) which I will need to get some more of.






Reply With Quote

Little Joe
