PDA

View Full Version : bags of fun (a TITAINIC) delema



slayerofmen
23-04-2009, 08:29
righto simple question.

to all those that own a warhound titan what is the best types of methods to get it together.

super glue only?

super glue and pinning?

and would 1mm pins be enough ?

also would soap and (warm) water be enough to clean off the casting layer?

Ganymene
23-04-2009, 09:00
This should probably be in M,P&T, but...


I use dishwashing liquid and warm water to clean the release agent off of FW models, use a toothbrush to scrub it and you'll be good.

I would definitely pin everything you can, or use magnets for easy transport/weapon swaps. I'm not sure exactly about the size of the pieces for a Warhound, but I usually use the largest pins I can get in the joint. The bigger the pin, the stronger the joint, so I would use as large of a pin as you can.

And always wear a mask when filing/sanding resin to protect your lungs.

Hope that helps. :)

genestealer_baldric
23-04-2009, 09:08
a good method i found for cleaning resin is using lemon jucie from a fresh lemon in hot sopy water and toothbrush and many hours of scrubbing later your titain will be sorted.

also try to sand it or cut it outside to get rid of the dust,