PDA

View Full Version : Can someone help me?



_dandaman_
27-08-2010, 22:48
You see everyone, I'm a straping young student on a fixed budget, and I'm looking to cut corners whenever I can. I'm in the middle of my dwarf army, and I really love hammerers, and I'm looking to use them, unfortunately they cost lots and lots of money, so I was thinking of using the reaper kneebreakers, so does anyone know how they look size wise and quality wise compared to the GW minis? So basically would the kneebreakers look ok next to my dwarf lord on shieldbearers? And does anyone have any ideas as to how I would make command?

Thanks;

Dan

major soma
27-08-2010, 22:50
Reaper make their minis in three scales if they're from the Warlorld range then they should be suitable however you'll have to put them on smaller bases as the standard Reaper bases are the same size as GW chaos warrior bases.

m1s1n
28-08-2010, 00:04
It takes some plastic bitz, but it isn't too hard to convert plastic warriors into hammerers.

JollyGoodChap
28-08-2010, 00:08
There are a lot of websites that offer upto 20% discounts on Warhammer models so you could try one of those? :D

_dandaman_
28-08-2010, 01:08
There are a lot of websites that offer upto 20% discounts on Warhammer models so you could try one of those? :D

The only problem is that even the 25 USD boxes at 20% off come to about $20, so id have to pay $40 for 10, while the kneebreakers on ebay are 9 for $30! Hmmmm, I may try your aproach though.

Casshole
28-08-2010, 06:07
Just make sure to keep it at the 28mm range and youll be good

SiNNiX
28-08-2010, 10:04
BigbyWolf! Check your PM's!

Haha, I'm such a loser.