thewizard99

04-07-2007, 21:59

hello, im wanting to make a bloodbowl gaming table, which has the playing feild the dugouts and everything, but i need to know how i sould do it, i need some type of makers for the individual squares, there size and how many, i dont have the original box or anything, and the ones online arnt accul size.

id be basically having a mdf board of the right size with a 2 inch over hang for the outskirts of the feild, and then a 4 inch bit on the end for the dugout for each player.

the so bassicaly

| 4inches | 2inches | playing feild in inches | 2 inches | 4 inches |

this goes long ways down the playing feild.

then of course you have the width, which would be feild width.

but the main consern is the marking of the feild, like the little square, and the + parts to make the feild

like this

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

how would i do the + in foam bord? wood or something?

id be basically having a mdf board of the right size with a 2 inch over hang for the outskirts of the feild, and then a 4 inch bit on the end for the dugout for each player.

the so bassicaly

| 4inches | 2inches | playing feild in inches | 2 inches | 4 inches |

this goes long ways down the playing feild.

then of course you have the width, which would be feild width.

but the main consern is the marking of the feild, like the little square, and the + parts to make the feild

like this

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

+ gap + gap + gap + gap +

how would i do the + in foam bord? wood or something?