ok, if Varyngr means nothing to you then look here:
http://warseer.com/forums/showthread.php?t=89616
here: http://warseer.com/forums/showthread.php?t=59021
and especially here: http://warseer.com/forums/showthread.php?t=46402
Think of them as the ones who didnt get eaten by the Nids...
Important
I later changed the type of model I was using. The Victrix are here and next page. Final models start next page too
started work at long last:
from left to right:
1 two hacksaw cuts above and below knee, didn't lose enough height.
2 An unmolested model held together with bluetack
3 Two double hacksaw cuts above and below knee
4 two penknife cuts above and below knee.
I'm going with no3. the penknife saw cause too much incidental damage just brushing past and two hacksaw cuts don't remove enough material.
Finding this I let my orky side take over and superglued two sawblades together. I'm still not sure they'll be short enough but never mind.
Intended list:
5 holmgard
10 clangard
5 foragers
2 gunships
1 prospector's trike
5 outriders
5 embittered
4 highgard
1 battle mechanik + 3 bot retinue
1 grudgekeeper
5 stoneteeth
5 iron heads
1 Warleader
1 Living Ancestor
so that's 48 bodies and 10-20 sheilds to start with plus robots
Casualties so far: one chair and one lightbulb. don't ask.