Another newbie, welcome aboard.

Gatling Blaster:

While I am in the process of making a HellStrom Cannon I figure it wouldn't hurt to build a Gatling Blaster quick change set of barrels as well.

That way I can have the option of either weapon with minimal trouble.

The first thing is to make the six Barrel mount cone.

Here we see the cone which is simply a disk of styrene about ten inches in diameter with a center eight inches in diameter removed.

I then took the two inch wide strip and made a cone about 4 inches wide so there are two layers of 0.020 styrene which should be strong enough once the cone is covered with reinforcing bitz of sheet styrene.

https://i.imgur.com/UqQTie0.jpg


Once the glue is dried I have the rough form of the bell housing that is ready for detailing.

https://i.imgur.com/mGC0sIb.jpg